ESB With Signal Control

These units are a basic ESB Model with an additional built-in feature that enables the start, stop and run functions to be controlled by a 2-wire signal switch or switches when there is a power failure.

The signal control system is designed for use where an interrupted or less than continuous power supply is required. By using this system, the run time plus the overall operating expenses will be considerably reduced. Auto Power has the only available control of this type.

ER 5000 AND ESB WITH SIGNAL CONTROL

To operate using a 2-wire signal control:

1. Connect the control switch to the green lugs.

2. Manual switch off.

3. Master switch on.

All start and stop functions are now managed by the control switch.

The manual switch and the green connecting lugs are located on the grey

electrical enclosure.

To operate manually:

Without a control switch connected and the master switch on, the generator can be controlled by the manual switch.

These units may be exempt from inspections and permits in some locations because they are portable units and do not need to be installed. However, if any permits, inspections or modifications are required for legal operation, they are the sole responsibility of the purchaser.

These units are not legally qualified for operations that require stand-by power in Health Care settings. The E5000 units are medium duty service rated and should not be operated near or at max output for extended time periods.

ESB WITH SIGNAL CONTROL SPECS

Engine

388 CC – approximately 13 HP

Fuel type – LP

Fuel consumption:

½ load .56 GPH

¾ load .71 GPH

full load .95 GPH

4.25 lb = 1 gallon – GPH = Gallons per hour

Generator

Rated – Output 5KW continuous, 5.9 KW surge

Rated – 41.5 Amp @ 120 V

20.7 Amp @ 240 V

Receptacles

4 – 120 V NEMA 5 – 20R

1 – 120 V NEMA L5 – 30R

1 – 240 V NEMA L14 – 30R Locking plug

These generators produce 25% or less total harmonic distortion. You can run your electronics on these generators, but as in any situation, it is recommended to use a properly rated surge protector between your electronics and the power source.

Dimensions

w/o wheel kit 27 X 21 X 23

W / wheel kit 32 X 27 X 26

Weight 210 lb

72 decibels @ 27 ft

Standard Included Features

Circuit breakers

12 V – 15 AH / 20 hour battery

Portability kit

Over crank and over voltage protection

Hour meter

Low oil shut down

LP regulator and hose

Engine driven battery charging

Voltage gauge

Automatic positive fuel shut-off

Repeat crank-ability

Delayed engagement of generator

Delay startup

2 Lugs – connecting points for all 2-wire controls

Manual control switch

Power cord with L 14 – 30 plug

Battery maintainer – charger that operates when power is connected

Built in, automatic 30 amp double pole latching transfer switch

Price

ESB Model with signal control $1865.00 (Plus sales tax in the state of Ohio)